Great-plains 3S-4000F Predelivery Manual Manuel d'utilisateur télécharger pdf (Page 27)

9/12/2009

195-242Q

Setup

Align Transfer Drive Shaft

After wing boxes are properly aligned, the transfer

drive shaft must be aligned so the pair of break-

away jaws are fully engaged and are concentric.

The 7/8 inch hex drive shafts holding the clutch

jaws should not contact each other when wing

boxes are properly aligned and back against their

stops.

1. Place a 4x4 or similar sized block ahead of

the wing gauge wheels and pull forward or

push wing box frames back until the toolbar is

ﬁrmly against toolbar stop bolts on the center

box frame.

2. Refer to Figure 11. To align the clutch jaws

vertically, loosen the two 5/8 inch bolts (1) on

the backside of the adjustment plate (2). Slide

the plate up or down in the desired direction.

Figure 11

Transfer Drive Shaft Vertical Adjustment

18953

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34 35

Pas de commentaire

Great-plains 3S-4000F Predelivery Manual Manuel d'utilisateur Page 27