Great-plains P13529 Manuel d'utilisateur télécharger pdf (Page 19)

19X-Press

Operating Instructions

2.6.4 Hitching a Rear Roll to

the X-Press

Follow procedure 2.4 (page 16) to couple a

tractor to the X-Press. Once the tractor is

safely connected to the implement and in its

folded setting, raise the machine fully clear of

the ground.

1. Reverse the X-Press up to the roller.

2. Align the X-Press and roller drawbars,

lower the X-Press to the ground and

depressurise the lift hydraulics.

3. Raise / lower the axle as required to

align the respective machines‘

drawbars and couple together.

4. Couple the rear roll to the lift circuit of

the X-Press, ensuring that the hoses are

connected to the corresponding circuit

on the trailing machine.

5. Couple the rear roll wing (fold) circuit to

the wing (fold) circuit of the X-Press.

6. Fully raise the X-Press and the roll clear

of the ground.

7. Check that all transport straps / devices

are fitted.

2. Transportation / Installation

Prior to leaving the field to travel on a public

highway ensure that any clods of soil are

removed from the machine to prevent them

from fouling the road.

MAXIMUM ROAD TRANSPORT SPEED 18

MPH (25 KPH).

2.6.3 Changing from Work to

Road Transport (X-Press

Towed Behind a Disc Harrow)

1. Remove the disc harrow wing locking

bolts.

2. Operate the hydraulics to raise the disc

and X-Press.

3. Operate the hydraulics to fold the wings

on both the disc harrow and the X-

Press.

4. Fit the transport straps to both

machines.

It may be necessary to shorten the

levelling springs until the top frame

of the disc harrow is horizontal or

slightly nose down before moving the

machines.

Shortening the X-Press drawbar cylinder will

increase the loading on the rear of the disc

frame. If necessary this can be used to level

the disc top frame for road transport.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Commentaires sur ces manuels

Pas de commentaire